Demevalos’ Guide to Creating Y-Split Braided Cables

In this guide, we will take you through the step-by-step process of creating your very own audio cable using high-quality Mogami w2893 wire. With just a few basic tools and materials, you’ll be on your way to a customized audio experience in no time.

Materials Needed:

  • Mogami w2893 wire
  • Soldering station
  • Solder
  • Heat shrink
  • Paracord
  • Connectors
  • Pliers

Step 1: Measuring the Cable

Begin by determining the desired length of your cable. Gently cut open the protective sheathing of the Mogami wire, being careful not to damage the copper wires inside.

Step 2: Removing the Sheathing

Cut the sheathing at one end of the wire, then flip it to cut the other end. Gently pull out the wire to completely remove the sheathing.

Step 3: Unraveling the Wire

Separate the copper wires from the paper and remove any nylon strings. Retain the paper for now. Carefully untwist the wires until you’re left with just the wire and the nylon strings.

Step 4: Preparing the Paracord

Cut four strands of paracord slightly longer than the wire to prevent fraying. Remove the inner strands of the paracord.

Step 5: Threading the Wire

Guide the wire through the paracord by pushing it through. For hard-to-reach sections, use the “snake and pinch” technique.

Step 6: Soldering the 1/4 inch Jack

Combine and solder the black and clear wires for the ground connection. Similarly, solder the red and blue wires for the positive connections. Ensure that no connections touch where they shouldn’t.

Step 7: Braiding the Cable

Follow the pattern “Over two, over one. Under two, under one” to neatly braid the wires. At the Y split, separate and twist two ground wires and two positive wires, securing them with heat shrink.

Step 8: Soldering the 2 Pin Connector

Connect the wires to the connectors. Remember, the larger pin is for ground, and the smaller pin is for positive. Use a strain relief to secure the connections.

Step 9: Test and Finish

Test each connection with a multimeter to confirm their correctness. Tighten the connectors and apply hot glue for additional security. Conduct a sound check to ensure everything is functioning correctly.

Congratulations! You’ve successfully crafted your very own custom audio cable. Now, relish in the enhanced audio experience brought to you by your personalized creation. Enjoy your music like never before!

Leave a Comment